Universal Cross-Roll Piercing and Elongating Test Mill "Vitkovice"
Universal Cross-Roll Piercing and Elongating Test Mill "Vitkovice"
YOM: 1988
New set up 2012
Control ABB 800PEC
Siemens S7
Roll diameter 340 to 420mm
Body length 350mm
Feed angle: two roll arrangement 0 to 17 degrees, three roll arrangement 0 to 15 degrees
Angle of conic, divergent, or convergent: two roll arrangements 0 to5 degrees, three roll arrangements 0 to 7,5 degrees
Drive power of motors 2x280kw ABB Motors HXR500LH6 from 2010
Roll force max 650 kN per roll
Roll torque max 55 kNm per roll
Rotational speed of rolls 72to 225 rpm
Length of initial material 550 to 1000 mm
Diameter of initial material 70 to 133 mm
Rolled length max 2700 mm
Equipped with:
1. Kawasaki MX 350L
(Lot 46-2)
YOM 10-2009
Model 044F-D001
Serial: MX3500051
2. Pyrometer 2pcs
(from Lot 54)
Luma Sense IS 140 MB 16 Laser-PL
600°C zo 1600°C
3. Pyrometer 1pc.
(from Lot 55)
LumaSense IPE 140 MB12 Laser-PL
50°C to 1200°C
4. Speed Measurements 2pcs.
(from Lot 56)
Polytec LSV-300
1,5m distance
5. Diameter Measurement 1 pc.
(from Lot 58)
Zumbach ODAC-310DP
Max OD: 300mm
6. Length Measurements 1pc.
(Lot 59)
ASTECH LIXUS-i PN 8192
Download Documents
Sale Specific Terms
These terms are the sale specific terms as mentioned in article 1.1.18 of the terms and conditions below. This sale is a private treaty sale, as described in article 1.1.14 of the terms and conditions below. When a bid is accepted, a sales agreement will be made to be signed by the buyer and the seller. In the sales agreement, the buyer and seller will state the terms for payment and removal, that may deviate from the terms and conditions below.
Terms and conditions
The following terms and conditions ("terms") are the terms on which hilco industrial acquisitions bv (“hilco”), at jan van goyenkade 10-2, 1075 hp amsterdam, the netherlands, registered under the following number 60720700 at the chamber of commerce in amsterdam, sells equipment (defined below) at auctions (defined below) or by means of private treaty sales (defined below) and supersedes all other terms and conditions relating to the subject matter of these terms. These terms are the terms subject to which hilco shall, either on its own behalf or as agent for the vendor (defined below), sell equipment to a buyer (defined below) by way of auction or private treaty sale.
The buyer's attention is in particular drawn to the provisions of clause 8 and the buyer should note that:
All equipment is sold 'as is, where is' (with all faults, imperfections and defects) No guarantees and/or warranties are provided by hilco in respect of any equipment. It is the buyer's responsibility to inspect equipment prior to bidding on such equipment or making an offer in respect of such equipment. All sales are final – no exceptions. Sales may be subject to a buyer's premium (defined below), the rate of which will vary from sale to sale. All auctions (defined below) are subject to the conditions, valid in the country, where the auction takes place.
DEFINITIONS AND INTERPRETATION
The following words and phrases used in these Terms shall have the following meanings, except where the context clearly requires otherwise: "Advertising Material" means brochures, pamphlets, advertisements and any other marketing material (in both electronic and printed format) used by HILCO to market and promote the Auctions and/or any Private Treaty Sale;
