14-Stands Calibration Mill (Calibreur)
Type: Multi-stand — 14 stands inline arrangement, each equipped with two cylindrical-grooved rollers (galets à gorge cylindrique) arranged at 90° in relation to the previous one
Function: Progressively reduction of tube’s diameter while maintaining roundness and concentricity
Capacity:
– Tube diameter: Ø 80 to 203 mm
– Tube Length: 4,000 to 10,800 mm
Associated Equipment:
– 90 bar pump high-pressure descaling system before first stand
– Guiding system for tube alignment into the rolling stands
– Stands’ maintenance related equipment
Motor & Drive:
– Single 500 HP Motor (2014) with two main transmissions and reducers for each roll
– Voltage: 5000 V AC
– SCHNEIDER PLC
Tooling:
– Number of stands’ assembly: 30 available in total (on- and off-line)
– Wide variety of rollers’ sets
– Diameter reduction per stand: 2.7%
– Total diameter reduction: 8–15% (typical operating range)
– Speed increase per stand: 1.7%
This lot is part of a combination lot: 10 Hot Rolling Mill
Not the machine you are looking for?
Download Documents
Sale Specific Terms
These terms are the sale specific terms as mentioned in article 1.1.18 of the terms and conditions below. This sale is a private treaty sale, as described in article 1.1.14 of the terms and conditions below. When a bid is accepted, a sales agreement will be made to be signed by the buyer and the seller. In the sales agreement, the buyer and seller will state the terms for payment and removal, that may deviate from the terms and conditions below.
Terms and conditions
The following terms and conditions ("terms") are the terms on which hilco industrial acquisitions bv (“hilco”), at jan van goyenkade 10-2, 1075 hp amsterdam, the netherlands, registered under the following number 60720700 at the chamber of commerce in amsterdam, sells equipment (defined below) at auctions (defined below) or by means of private treaty sales (defined below) and supersedes all other terms and conditions relating to the subject matter of these terms. These terms are the terms subject to which hilco shall, either on its own behalf or as agent for the vendor (defined below), sell equipment to a buyer (defined below) by way of auction or private treaty sale.
The buyer's attention is in particular drawn to the provisions of clause 8 and the buyer should note that:
All equipment is sold 'as is, where is' (with all faults, imperfections and defects) No guarantees and/or warranties are provided by hilco in respect of any equipment. It is the buyer's responsibility to inspect equipment prior to bidding on such equipment or making an offer in respect of such equipment. All sales are final – no exceptions. Sales may be subject to a buyer's premium (defined below), the rate of which will vary from sale to sale. All auctions (defined below) are subject to the conditions, valid in the country, where the auction takes place.
DEFINITIONS AND INTERPRETATION
The following words and phrases used in these Terms shall have the following meanings, except where the context clearly requires otherwise: "Advertising Material" means brochures, pamphlets, advertisements and any other marketing material (in both electronic and printed format) used by HILCO to market and promote the Auctions and/or any Private Treaty Sale;
