SHELL / BADGER N.V. Crude Distillation 3 (CD-3)

Lot No. 1
Previous Lot
Next Lot
Terms & Conditions
Contact Us
Lot No. 1

SHELL / BADGER N.V. Crude Distillation 3 (CD-3)

Year: 1965
Crude Oil Atmospheric and Vacuum Distillation and Naphtha Stabilizer.
Year of manufacture 1965
Process Design by Shell
Process Engineering by BADGER N.V.
Feed = Original design, paraffinic crude (21 d/month), naphthenic crude (7 d/month), after 2015 Revamp is 100% naphthenic crudes. Crude oil with Total Acid Number (TAN) up to 4,2 (TJP), 3,3 (Laguna), (range of Viscosity = 5,5 – 144 cst/100°C)
Throughput max. 12.000 t/d – original design
Current Process Parameters (after 2015 Revamp)
Atmospheric Distillation:
Throughput max. 6000 t/d
Operational operating temperature = 355°C
Operational operating pressure = 2,5 bar
Vacuum Distillation:
Throughput = max. 4500 t/d
Operational operating temperature = 380°C
Operational operating pressure = 0,2 bara
Naphtha Stabilizer C-0807:
Throughput = max. 2000 t/d
Operational operating temperature = max. 260°C
Operational operating pressure = max. 14,5 bar
1984 – replacement of middle section of column C-0850 to cladded stainless steel (HTAN corrosion protection)
2003 to 2020 – replacement of heat exchanger bundles in cooling water service to duplex steel (corrosion protection)
2009 to 2015 – fugitive emission compliance upgrades of all relevant pump seals, or pump replacements
2009 – Complete retubing of all furnaces and transfer lines to stainless steel (HTAN corrosion)
2015 – major revamp to process 100% naphthenic crude oil @ 6000 t/d, new furnace stack, conversion to natural gas firing, new top section C-0851 to cladded stainless steel, upgrade of piping above 240 °C to stainless steel (HTAN corrosion)
2020 – new top section of vacuum column C-0850 to cladded stainless steel, further upgrade of piping above 210 °C to stainless steel (HTAN corrosion)
2022 – Decommissioning

Download Documents

Sale Specific Terms

These terms are the sale specific terms as mentioned in article 1.1.18 of the terms and conditions below. This sale is a private treaty sale, as described in article 1.1.14 of the terms and conditions below. When a bid is accepted, a sales agreement will be made to be signed by the buyer and the seller. In the sales agreement, the buyer and seller will state the terms for payment and removal, that may deviate from the terms and conditions below.

Terms and conditions

The following terms and conditions ("terms") are the terms on which hilco industrial acquisitions bv (“hilco”), at jan van goyenkade 10-2, 1075 hp amsterdam, the netherlands, registered under the following number 60720700 at the chamber of commerce in amsterdam, sells equipment (defined below) at auctions (defined below) or by means of private treaty sales (defined below) and supersedes all other terms and conditions relating to the subject matter of these terms. These terms are the terms subject to which hilco shall, either on its own behalf or as agent for the vendor (defined below), sell equipment to a buyer (defined below) by way of auction or private treaty sale.

The buyer’s attention is in particular drawn to the provisions of clause 8 and the buyer should note that:

All equipment is sold ‘as is, where is’ (with all faults, imperfections and defects) No guarantees and/or warranties are provided by hilco in respect of any equipment It is the buyer’s responsibility to inspect equipment prior to bidding on such equipment or making an offer in respect of such equipment All sales are final – no exceptions Sales may be subject to a buyer’s premium (defined below), the rate of which will vary from sale to sale All auctions (defined below) are subject to the conditions, valid in the country, where the auction takes place DEFINITIONS AND INTERPRETATION .1. The following words and phrases used in these Terms shall have the following meanings, except where the context clearly requires otherwise: "Advertising Material" means brochures, pamphlets, advertisements and any other marketing material (in both electronic and printed format) used by HILCO to market and promote the Auctions and/or any Private Treaty Sale;

Contact Us From